Readme.txt Copyright Portlock Software 2000-2007 All rights reserved ************************************************************ Portlock Boot CD for NetWare Version 4.01 ************************************************************ This CD is designed to be a bootable Windows operating system that will allow users to use Portlock Storage Manager on systems that are either corrupt or contain disks without a bootable operating system. This CD provides networking as well as a GUI interface that enables users to image and restore over a TCP/IP connection. ************************************************************ Porlock Storage Manager for NetWare Version 4.01 ************************************************************ Portlock Storage Manager for NetWare may be installed from this CD. Portlock Storage Manager for NetWare is located in the /stormgr/netware folder of this ISO. Running pinstall.nlm, located in the /stormgr folder, will install Storage Manager to a specified location on your NetWare server. ************************************************************ Version 1.0 ************************************************************ New Features: 1. Contains the latest PSM 4.01 Build for NetWare 2. Contains send.exe and recv.exe 3. Based on Windows Server 2003 Enterprise 4. Altered startnet.cmd file to load Portlock Storage Manager at startup 5. winPE txtsetup.sif has been updated to load Intel chipset drivers at boot time. This resolves the issue of the winPE CD existing to a blue screen at startup. 6. The following drivers have been updated: Storage: VMware VMSCSI virtual SCSI disk driver Intel Sata RAID chipset drivers Intel Sata RAID storage drivers LSI SAS storage controller drivers Emulex fibre channel storage controller drivers Promise FastTrak SX4000 series ATA RAID storage controller driver VIA SATA RAID storage drivers Qlogic QLA cards. Compaq G5 series SATA/SAS/SCSI controllers Network: Intel 100Mb, 1000Mb and 10Gb cards Broadcom NetXtreme 1000Mb cards Broadcom 440x cards Realtek 810x cards Marvell Yukon Gigabit cards Known Issues: 1. The winPE-based Boot Cd must boot in Legacy mode on EFI systems. The dual-boot catalog tools will not be released by Microsoft until February. 2. This version of winPE does not support hotplug devices. All USB devices must be attached at or before boot time in order for them to be recognized. 3. This version of winPE does not support writeable RAM disks. Any files created must be saved to a hard disk, USB drive or floppy diskette. 4. Static IP addresses must be configured in the winbom.ini file before the ISO image is burned to a CD. 5. Storage and NIC drivers may not be inserted into the Portlock Boot CD at runtime. these drivers must be added to the build environment and a new ISO must be created. 6. This version of the Portlock Boot CD does not support tape drives.